Joe and Tony are great guys and will help anyone out that requires any engine machining work.

I took a disassembled, Ford 390 block, crank and other hard parts to them to have them hot tanked, bored and honed. I got it back and found they had already Installed the main bearings, crank and main caps. They then wrapped the entire block in thick plastic. I was concerned why they would have installed the crank without asking or telling me. I got it home and removed the crank to check clearances. I then learned why they installed the crank. They had broken a piece off the rear main cap housing of the block and filled it with black silicone concealed behind the back of the crank. They denied breaking the piece off the block but did machine another block that I had to buy. I would never recommend, trust or use this shade tree, deceptive shop again. True story

Great shop. Work was fast and done perfectly. Ill be taking everything there in the future.

Great shop! I needed them to shave 0.20 off of my rocker stands down to fit ARP studs. And they went above and beyond by stamping each one with 1-6 numbers! BTW it is cash only.

Took some Subaru heads here to get machined after the shop I used to go to shut down because they retiredand they seemed to have almost no knowledge on what to do. Complained that a valve was sticking out slightly and couldnt machine it be cause of that. All that took was moving the cam gear by hand to move in the right position. Went and picked up the head and he had to take VVT assembly off to machine it. Which Ive never had other shops have to do. I was putting the head back on and noticed that the solenoid was loose. Upon further inspection it looked like he hit it with his machine and broke it and then decided to take it off. He did refund my money and I decided to try him again a couple weeks later this time with I took everything I thought need to come off for him. I took it there and there was one bracket and sensor he needed to come off and he wouldnt take it off because he didnt want the responsibility of it, which I understand. So I asked him if I could barrow a 10mm and Cresent wrench to take them off right there and he said he wouldnt loan tools. Complete unprofessional machinest will never use him again and would never recommend. I now use Rev motors for my work. Way more professional, cheaper, and quicker turn around time.

Solid advisers